Names this setup, your targets and your mix as one recipe. Everything you change from here saves to it.
Takes the tank layout, acid dosing tank, ratios, and reservoir/tank volumes. It does not change which recipe you are working on.
None of your saved recipes carry a tank layout yet (they were saved before this was tracked). Open one on the Calculator, then save it again on Fertilizer Target Recipes to capture this system's tanks.
The readings and nutrient fields below hold the selected test's values, and save as you type. Switch tests or hit + New to start another. The calculator uses the selected one.
Water readings
The descriptive numbers at the top of most reports. Leave 0 for anything not listed.
Measured nutrients (elemental ppm)
From your water report, in elemental ppm (mg/L). Leave 0 for anything not listed.
Trace elements aren't on a standard panel. Add them only if your lab ran them.
Reservoir
Concentrate tanks
Each tank is a concentrate your injector pulls from at its dilution ratio. Keep incompatible salts apart so nothing precipitates: calcium in one tank, sulfates and phosphates in another. You assign fertilizers to tanks in the calculator.
Batch tank
The buffer tank your injector fills with final-strength solution before you irrigate from it. The calculator tells you the total fertilizer in a full tank and how fast your concentrate drains.